NEWS:   Honda is recalling certain 2011-2012 Ridgeline vehicles

FEBRUARY  2012 -- Honda is recalling certain model year 2011-2012, Ridgeline vehicles manufactured from August 25, 2011, through November 29, 2011. The spare tire installed in affected vehicles may not match the information on the vehicle’s tire information placard. Therefore, these vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 110, “tire selection and rims for motor vehicle.” an incorrect label could lead to improper tire inflation which could result in a tire failure, increasing the risk of a crash. Honda will notify owners, and dealers will inspect the spare tire and if necessary, exchange the spare tire assembly or replace the tire information placard free of charge. The safety recall is expected to begin on or before January 31, 2012. Owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov .

MORE RECALL INFO: 

• Honda Ridgeline

JANUARY 2010 - Honda is recalling certain model year 2006 and 2007 Honda Ridgeline vehicles manufactured between January 17, 2005, and June 7, 2006. A wiring harness connector for the heating, ventilation and air conditioning (HVAC) blower motor located under the passenger's side of the instrument panel may be accessible to kicking by the front seat passenger's feet. If this occurs, the connector terminal may overheat, and this may cause the wire insulation to melt or the wiring connector to melt. Should the wiring insulation melts and the exposed wires contact each other it will result in a short circuit and a fire could occur. Dealers will inspect and if the wiring connector is damaged it will be replaced and all vehicles will have the protective cover installed free of charge. The safety recall is expected to begin during March 2010.  10V-001

NOVEMBER 2007 -- Honda is recalling 410 MY 2008 Ridgeline vehicles. The hole in the sheet metal front bulkhead that serves as the base and pivot point for the hood support rod was not punched to specification. The hood support rod may fail to hold the hood in position due to insufficient strength. If the hood support rod hole fails, the hood could fall increasing the risk of injury. Dealers will inspect the prop rod base hole and, if necessary, install reinforcement parts free of charge. Honda telephoned all owners on November 26, 2007, asking them to bring their vehicles in to their dealers for inspection. A followup letter will be mailed during January 2008.   07V542

NEWS:    Engine problems force Honda recall

WASHINGTON - March 19, 2007 - Honda Motor Corp. said Monday that it was recalling about 165,000 vehicles from the 2005-06 model years in the United States to deal with potential engine problems

Honda said the recall affected 2005 models of the Acura RL, TL and TSX sedans, 2005 Honda Accord coupes, sedans and hybrids, 2005 Odyssey minivans and 2006 Ridgeline trucks.

The move is part of a global recall because of similar problems, said Honda spokesman Chris Martin. Details on the total number of vehicles and the number of countries where the vehicles were sold were not immediately available, he said.

Martin said the automaker discovered that sealer material leaked onto a coil wire inside the fuel pump relay on some of the vehicles. The wire can become brittle and snap, causing the engine to stall or fail to start.